KYOCERA S-9100DN User Manual download pdf (Page 94)

Appendix B Expansion Memory

B-2





 DIMMs to be used

See your Kyocera Mita dealer for purchasing information of the

DIMMs that are best suited for use with this printer. 16 MB, 32

MB, 64 MB, and 128 MB DIMMs can be used for memory ex-

pansion.

Insert the DIMM into the socket as shown below.

Remove the DIMM from its package.

Open the clips on both ends of the DIMM socket.

Insert the DIMM into the socket, so that the notches on

the DIMM align with the corresponding protrusions in

the socket.

Close the clips of the DIMM socket to secure the

DIMM.

When you finish installing the DIMM, reinsert the main

circuit board into the printer by reversing the removal

procedure.

To remove a DIMM, carefully pull the end clips outwards, then

pull the DIMM out of the socket.

Return the main circuit board to the printer by reversing the pro-

cedure explained in Removing the Main Circuit Board from the

Printer on page B-1.

After you finish installing DIMMs in the printer, test the printer to

see if the installation was successful. To test the expansion

memory, proceed as follows:

Make sure the printer is turned off. Plug the power cord

into the printer and turn the printer on.

Press the

key on the operator panel.

Press the 3 or 4 key repeatedly until Print Status

Page appears.

Press the ENTER key twice.

If the installation was successful, the amount of memo-

ry shown on the status page will correspond with the

amount of expanded memory. (The factory installed

memory size is 32 MB.)

2. Installing DIMMs

2.1 Removing DIMM

2.2 Testing the Expansion Memory

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 142 143

No comments

KYOCERA S-9100DN User Manual Page 94