KYOCERA S-9100DN User Manual Page 85
- Page / 143
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
6-1
Chapter 6 Maintenance
This chapter explains how to replace the toner container and the
waste toner box and how to clean the internal parts of the printer.
When you replace the toner container, make sure to clean the in-
ternal parts of the printer.
The toner container in the printer should be replaced as soon as
the message display shows Toner low TK-70 or soon after.
If you continue to use the printer, eventually the toner supply will
be exhausted at which point the printer will stop printing and the
Replace toner Clean printer message will be shown in-
structing you to install a new toner kit.
Assuming an average toner coverage of 5 % and Ecoprint mode
turned off, the toner container will need replacing approximately
once every 40,000 pages.*
* For a new printer with a toner kit installed for the first time, the
number of copies that can be printed will be approximately
20,000.
Toner Kits to be Used
Name: TK-70 (40,000 pages)
Contents: Toner container
Waste toner box
Wiper cloth
Grid cleaner
2 plastic bags (for disposal of the old toner container
and waste toner box)
Installation Guide
• Be sure to distance items such as floppy disks during toner
container replacement.
• Be sure to clean the inside of the printer when replacing the
toner container.
• Use of original Kyocera Mita toner kits is highly recommended
to prevent printer trouble and ensure the long life of the printer.
Replace the toner container using the following procedures.
Open the printer front cover all the way.
Push the lock lever (blue colored) up and gently re-
move the toner container until its handle appears.
Do not pull the toner container all the way as it can fall
off and the toner spots the floor.
1. Toner Container Replacement
1.1 Toner Container Replacement Interval
NOTE
1.2 Replenishing Toner
NOTE
1
2
- Operation Guide 1
- CONTENTS 6
- Introduction 7
- IMPORTANT! PLEASE READ FIRST 8
- Caution Labels 8
- Installation Precautions 9
- Precautions for Use 10
- Cautions for Toner Handling 11
- Chapter 1 Names of Parts 12
- Chapter 1 Names of Parts 13
- Chapter 2 How to Load Paper 14
- Chapter 2 How to Load Paper 15
- 1.3 Setting Envelopes 16
- DATA ATTENTION 17
- 1.1 Operation Indicators 18
- 1.2 Message Display 18
- 1.3 Interface Indicator 18
- 1.4 Paper Size Indicator 19
- 1.5 Paper Type Indicator 19
- 1.6 Keys 19
- 2. Using the Operator Panel 20
- 2.2.1 Printing the Menu Map 26
- 2.2.2 Printing Status Page 26
- 2.2.3 e-MPS 27
- PERMANENT CODE JOB LIST 31
- VIRTUAL MAIL BOX LIST 32
- 2.2.5 Changing the Emulation 38
- 2.2.7 Using Page Set Menus 42
- EcoPrint setting is Off 46
- (default) 46
- EcoPrint setting is On 46
- WRITE INFORMATION 48
- PARTITION LIST 49
- 2.2.10 Operating a RAM Disk 50
- FORMAT INFORMATION 55
- 2.2.12 Paper Handling 56
- 2.2.13 Other Modes 63
- FS-9500DN 68
- Chapter 4 Troubleshooting 69
- 2. Print Quality Problems 70
- Chapter 4 Troubleshooting 71
- 3. Indicators and Messages 72
- 3.3 Error Messages 74
- 4. Correcting a Paper Jam 76
- 4.1 Jam in Paper Cassette 77
- 4.2 Jam at the MP Tray 77
- 4.3 Jam in Left Cover 1 78
- 4.4 Jam in Left Cover 2 79
- Chapter 5 Paper Selection 80
- Chapter 5 Paper Selection 81
- 2. Special Paper 82
- 2.2 Adhesive-Backed Labels 83
- 3. Paper Type 84
- Chapter 6 Maintenance 85
- Chapter 6 Maintenance 86
- Appendix A Fonts 89
- Appendix A Fonts 90
- Board and DIMM 93
- 2. Installing DIMMs 94
- 1. Parallel Interface 95
- 2. Serial Interface 96
- 3. RS-232C Protocol 97
- 4. RS-232C Cable Connection 98
- Appendix D Option Units 100
- Appendix D Option Units 101
- 2. Installing Option Units 102
- 2.4 Hard Disk 103
- 2.5 Memory Card 103
- Appendix E Specifications 104
- Appendix E Specifications 105
- Glossary 106
- Kyocera Mita Corporation 110
- Printer Driver Guide 111
- Regarding Tradenames 112
- Kyocera 112
- Mita Digital Library CD-ROM 112
- Contents 113
- (DF-70/DF-71) 118
- 2.1.6 Using the RAM Disk 120
- 2.1.7 Selecting the User Name 121
- Language 122
- 3.1 Setting the Paper Size 124
- 3.1.1 Custom Size Settings 126
- 3.1.2 Advanced Media Settings 127
- 3.3 Using the Booklet Mode 129
- 3.6 e-MPS 132
- 3.6.1 Using Job Retention 133
- 3.6.3 Using Code Job 141
Related products and manuals for Copiers KYOCERA S-9100DN
Copiers KYOCERA KM-1820 User Manual
(1 pages)
(1 pages)
Copiers KYOCERA KM-C830D User Manual
(161 pages)
(161 pages)
Copiers KYOCERA All Pinters User Manual
(58 pages)
(58 pages)
Copiers KYOCERA 1500 User Manual
(92 pages)
(92 pages)
Copiers KYOCERA KM-1820 User Manual
(147 pages)
(147 pages)
Copiers KYOCERA FS 9530DN User Manual
(172 pages)
(172 pages)
Copiers KYOCERA KM-4050 User Manual
(1 pages)
(1 pages)
Copiers KYOCERA FS-680 User Manual
(141 pages)
(141 pages)
Copiers KYOCERA FS-3820N User Manual
(227 pages)
(227 pages)
Copiers KYOCERA KM-1810 Datasheet
(4 pages)
(4 pages)
Copiers Kyocera CUA 25307 User Manual
(87 pages)
(87 pages)
© 2020, manymanuals.com. All rights reserved. | 0.381 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals