KYOCERA S-9100DN User Manual Page 13
- Page / 143
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Chapter 1 Names of Parts
1-2
1 Operator panel
Contains the keys and indicators for operating the printer.
2 Front cover
Open to replace the toner container or waste toner box.
3 Paper cassette 2
Second cassette that holds up to about 500 sheets of stan-
dard paper.
4 Paper guide
Adjust to the length of the paper to be set in the paper cas-
sette.
5 Paper stopper
Hold the lever and adjust the paper guide to the width of the
paper to be set in the paper cassette.
6 Paper cassette 1
First cassette that holds up to about 500 sheets of standard
paper.
7 Handles for transport
These handles must be held by at least 4 persons when lift-
ing or moving the printer.
8 MP (Multi-Purpose) tray
Load paper here when printing onto small-size or special pa-
per.
9 Main switch
Turn ON (I) before starting to print.
0 Face-down tray
Printed paper is stored here.
A Toner container
B Toner container release lever
Operate to replace the toner container.
C Waste toner box
Waste toner is collected.
D Cleaning knob
Pull and push back in after toner container replacement or
when print images become soiled with toner.
E Main charger unit
When replacing the toner container, install the grid cleaner to
clean the grid.
F Cleaning brush
Used to clean the internal part of the printer.
G Power cord
H Power cord connector
220 to 240 V-models only.
I Option unit connector
When using the option device, connect its cable to this con-
nector.
J Handles for transport
These handles must be held by at least 4 persons when lift-
ing or moving the printer.
K Left cover 2
Open when a paper jam occurs inside the left cover 2.
L Lock lever
Pull up to open the left cover 1.
M Left cover 1
Open when a paper jam occurs.
N Memory card slot
O Optional network interface card slot (OPT2)
For optional network interface card.
P Parallel cable connector
Connect the parallel cable to this connector in the parallel
printing.
Q Network cable connector
Connect the network cable to this connector in the network
printing.
R Serial cable connector
Connect the serial cable to this connector in the serial print-
ing.
S Optional hard disk unit slot (OPT1/HDD)
For optional hard disk unit.
N
O
P
Q
R
S
- Operation Guide 1
- CONTENTS 6
- Introduction 7
- IMPORTANT! PLEASE READ FIRST 8
- Caution Labels 8
- Installation Precautions 9
- Precautions for Use 10
- Cautions for Toner Handling 11
- Chapter 1 Names of Parts 12
- Chapter 1 Names of Parts 13
- Chapter 2 How to Load Paper 14
- Chapter 2 How to Load Paper 15
- 1.3 Setting Envelopes 16
- DATA ATTENTION 17
- 1.1 Operation Indicators 18
- 1.2 Message Display 18
- 1.3 Interface Indicator 18
- 1.4 Paper Size Indicator 19
- 1.5 Paper Type Indicator 19
- 1.6 Keys 19
- 2. Using the Operator Panel 20
- 2.2.1 Printing the Menu Map 26
- 2.2.2 Printing Status Page 26
- 2.2.3 e-MPS 27
- PERMANENT CODE JOB LIST 31
- VIRTUAL MAIL BOX LIST 32
- 2.2.5 Changing the Emulation 38
- 2.2.7 Using Page Set Menus 42
- EcoPrint setting is Off 46
- (default) 46
- EcoPrint setting is On 46
- WRITE INFORMATION 48
- PARTITION LIST 49
- 2.2.10 Operating a RAM Disk 50
- FORMAT INFORMATION 55
- 2.2.12 Paper Handling 56
- 2.2.13 Other Modes 63
- FS-9500DN 68
- Chapter 4 Troubleshooting 69
- 2. Print Quality Problems 70
- Chapter 4 Troubleshooting 71
- 3. Indicators and Messages 72
- 3.3 Error Messages 74
- 4. Correcting a Paper Jam 76
- 4.1 Jam in Paper Cassette 77
- 4.2 Jam at the MP Tray 77
- 4.3 Jam in Left Cover 1 78
- 4.4 Jam in Left Cover 2 79
- Chapter 5 Paper Selection 80
- Chapter 5 Paper Selection 81
- 2. Special Paper 82
- 2.2 Adhesive-Backed Labels 83
- 3. Paper Type 84
- Chapter 6 Maintenance 85
- Chapter 6 Maintenance 86
- Appendix A Fonts 89
- Appendix A Fonts 90
- Board and DIMM 93
- 2. Installing DIMMs 94
- 1. Parallel Interface 95
- 2. Serial Interface 96
- 3. RS-232C Protocol 97
- 4. RS-232C Cable Connection 98
- Appendix D Option Units 100
- Appendix D Option Units 101
- 2. Installing Option Units 102
- 2.4 Hard Disk 103
- 2.5 Memory Card 103
- Appendix E Specifications 104
- Appendix E Specifications 105
- Glossary 106
- Kyocera Mita Corporation 110
- Printer Driver Guide 111
- Regarding Tradenames 112
- Kyocera 112
- Mita Digital Library CD-ROM 112
- Contents 113
- (DF-70/DF-71) 118
- 2.1.6 Using the RAM Disk 120
- 2.1.7 Selecting the User Name 121
- Language 122
- 3.1 Setting the Paper Size 124
- 3.1.1 Custom Size Settings 126
- 3.1.2 Advanced Media Settings 127
- 3.3 Using the Booklet Mode 129
- 3.6 e-MPS 132
- 3.6.1 Using Job Retention 133
- 3.6.3 Using Code Job 141
Related products and manuals for Copiers KYOCERA S-9100DN
Copiers KYOCERA KM-1820 User Manual
(1 pages)
(1 pages)
Copiers KYOCERA KM-C830D User Manual
(161 pages)
(161 pages)
Copiers KYOCERA All Pinters User Manual
(58 pages)
(58 pages)
Copiers KYOCERA 1500 User Manual
(92 pages)
(92 pages)
Copiers KYOCERA KM-1820 User Manual
(147 pages)
(147 pages)
Copiers KYOCERA FS 9530DN User Manual
(172 pages)
(172 pages)
Copiers KYOCERA KM-4050 User Manual
(1 pages)
(1 pages)
Copiers KYOCERA FS-680 User Manual
(141 pages)
(141 pages)
Copiers KYOCERA FS-3820N User Manual
(227 pages)
(227 pages)
Copiers KYOCERA KM-1810 Datasheet
(4 pages)
(4 pages)
Copiers Kyocera CUA 25307 User Manual
(87 pages)
(87 pages)
© 2020, manymanuals.com. All rights reserved. | 0.163 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals