KYOCERA S-9100DN User Manual download pdf (Page 103)

Appendix D Option Units

D-4

Insert the hard disk into its slot on the main circuit board of the

printer. If a hard disk unit is installed in the printer, received data

can be rasterized and stored on this hard disk. This enables

high-speed printing of multiple copies using an electric sort func-

tion. Also, you can use the e-MPS functions. For details, see e-

MPS on page 3-11.

For details of available hard disks, see your dealer.

Turn off the printer and disconnect the power cord and

printer cable.

Remove the two screws and remove the slot cover

(OPT1/HDD).

Insert the optional hard disk unit into the slot.

Tighten the two screws to secure the hard disk unit to

the main circuit board.

Insert the memory card into the memory card slot located the

right side of the printer. A memory card is a microchip card that

may contain option fonts, macros, forms, etc. The printer reads

the contents of the card into its internal memory when printer is

turned on.

For details of available memory cards, see your dealer.

Turn off the printer.

Do not insert or remove a memory card while the power

is on. If the memory card is removed while the printer is

on, damage could result in the printer’s electronics or

the memory card.

Insert the memory card in the slot. Insert it with its label

surface facing toward the outside, connector end first.

Push it in all the way.

2.4 Hard Disk

2.5 Memory Card

NOTE

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 142 143

No comments

KYOCERA S-9100DN User Manual Page 103