KYOCERA FS-1010 User Manual download pdf (Page 49)

3-10

FS-1010

(2) Downloading the firmware from the parallel interface

This section explains how to download firmware data from the parallel interface. The printer system

can automatically recognize whether the data to be overwritten is for controller firmware.

CAUTION Downloading the firmware takes several minutes. Do not turn power off during

downloading.

NOTE MS-DOS is required for a downloading from the parallel interface. The

computer must be connected to the printer with a parallel cable.

1 Turn printer power on. Make sure the printer is ready.

2 At the DOS prompt, send the following command to the printer:

echo !R! UPGR “SYS”;EXIT;>prn

DOS COPY (/b) the data from the host computer to the printer.

3 Confirm that downloading was finished normally by the LED indicator. (See the table below.)

4 Turn power off.

5 Turn power on again. Check the printer gets ready.

Confirm the status page shows the new firmware version (See Service information on the status

page on page B-4). If downloading fails, the printer indicates an error display using the LED

indicators. To identify error, refer to the table on page 3-12.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 171 172

No comments

KYOCERA FS-1010 User Manual Page 49