KYOCERA FS-1010 User Manual download pdf (Page 100)

FS-1010

5-20

5-2-8 Removing and splitting the fuser unit

WARNING The fuser unit is hot after the printer was running. Wait until it cools down.

CAUTION When refitting the fuser unit, make sure the fuser unit gear and the printer’s drive

gear are properly meshed with each other. For this, rotate the main motor several

turns before fixing screws.

1. Remove the process unit. (See page 5-4)

2. Remove the top cover/face-down output tray, right and left covers. (See page 5-5, 5-6)

3. Remove the rear side cover 1.

4. Remove the two connectors 2.

5. Remove two screws 3.

6. Remove the fuser unit 4.

Figure 5-2-19 Removing the fuser unit

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 171 172

No comments

KYOCERA FS-1010 User Manual Page 100