KYOCERA FS-1010 User Manual download pdf (Page 163)

C-4

FS-1010

Parallel interface pin assignment

The pins of the parallel interface connector carry the signals listed below. The function for each

signal is detailed on the following page.

No. Terminal Signal No. Terminal Signal

1 nStrobe (STBIN1/2*) 19 Ground GND

2 Data1 (PAD0) 20 Ground GND

3 Data2 (PAD1) 21 Ground GND

4 Data3 (PAD2) 22 Ground GND

5 Data4 (PAD3) 23 Ground GND

6 Data5 (PAD4) 24 Ground GND

7 Data6 (PAD5) 25 Ground GND

8 Data7 (PAD6) 26 Ground GND

9 Data8 (PAD7) 27 Ground GND

10 nAck (ACKOUT) 28 Ground GND

11 Busy (BUSYOUT) 29 Ground GND

12 PError (PERROR) 30 Ground GND

13 Select (SELECT) 31 nInit (INIT*)

14 nAutoFd (AUTOFD*) 32 nFault (FAULT*)

15 Not defined NC 33 Not defined Pull-up (1kΩ)

16 Logic ground GND 34 Not defined NC

Chassis ground

GND 35 Not defined Pull-up (1kΩ)

18 Peri-logic H (VCC) 36 nSelect In (SELECTI*)

Maximum rated current for pin 18 is 400 mA (fused).

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 171 172

No comments

KYOCERA FS-1010 User Manual Page 163