KYOCERA DF-470 Installation Guide Page 49

  • Download
  • Add to my manuals
  • Print
  • Page
    / 76
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 48
LE 05 Command CenterLE 05 Command Center
LE 05 Command CenterLE 05 Command Center
Helpful hints
Entries
All entries in the Command Center have to be confirmed using the “Send” button,
only then are the data sent to the device.
Some entries take a little time so be sure to keep an eye on the progress bar
Some
entries
take
a
little
time
so
be
sure
to
keep
an
eye
on
the
progress
bar
.
Password
• The access password (admin00) should be changed as soon as possible so that
there is optimal protection
• In principle, it is possible NOT to define ANY password. Access to the Command
Center would then be unprotected (not recommended).
Password
forgotten/
unknown
The password can only be changed in the relevant Command Center menu. If the pass-
word is not known, the Command Center can neither be accessed nor can a new
password be defined.
The following strategy is helpful if the access password is not known:
• While installin
g
the device
,
a se
p
arate administrator account is set u
p
(
see
p
a
g
e 96
)
.
g,p p(pg)
Important: The account must have administrator rights!
• This administrator account can be used to access system settings via operation panel.
• Local authentication can be activated via the system settings.
• After that the administrator account can be used to acccess the Command Center.
Though the password has not been changed all settings in the Command Center are
Though
the
password
has
not
been
changed
,
all
settings
in
the
Command
Center
are
available.
• After making the required settings, local authentication (in the Command Center)
can be switched off again.
A password change, when the old password is not known, can only be carried out by
resetting the device:
• Reset via the Command Center
"Reset to factory settings" results in the loss of certain data. Make sure that
these data are saved before the reset is carried out.
Page view 48
1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 75 76

Comments to this Manuals

No comments