KYOCERA DF-470 Installation Guide download pdf (Page 56)

Filter (v4 and v6)

LE 05 Command CenterLE 05 Command Center

Filter

(v4

and

v6)

Measure Setup of exclusive communication addresses

Recommendations • Only very specific computers may connect to the device.

• Only a very specific address range may communicate with the device within the

wor

• When communicating, the device may only use specific protocols.

Pre-conditions Administrative access to the Command Center.

Notes • This page is linked to the menu "Basic/device security".

• A total of ten filters is available, that can be set independently of each other.

• After the settings are made, the network interfaces have to be re-initialized.

1 IP address

IP address of the computer with which the device is to communicate.

Depending on the definition of the subnet mask, the segment address that is entered determine the

Depending

the

definition

the

subnet

mask,

the

segment

address

that

entered

determine

the

kind of communication that is allowed with the device.

2 Subnet mask

Depending on the entry of the IP address, the subnet mask defines the area (segment) within which

communication with the device is possible.

3Protocols

The above settings are only applicable for the protocols that have been marked. Protocols that have not

been marked are excluded from the communication!

Cf ( 4)

iguration example

(

IPv

IP address: 192.168.100.xxx (x=any)

Subnet mask: 255.255.255.0

All computers within the address area of the IP: 192.168.100.1 to IP: 192.168.100.255 may communicate

with the device (provided that at least one protocol has been marked).

All other computers are excluded from communicating.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 75 76

Comments to this Manuals

No comments

KYOCERA DF-470 Installation Guide Page 56

Comments to this Manuals