KYOCERA FS-1325MFP Installation Guide download pdf (Page 76)

2-56

Preparation

SNMP Traps Tab

No. Item Description

1 Host name Enter the host name of the machine.

MAX characters: 16

2 LAN interface Select the type of LAN interface installed on the machine.

You can also select check boxes for available port types that the machine uses for

communication: LPD setting, Raw port, WSD print.

Value: Auto, 10Base-half, 10Base-full, 100Base-half, 100Base-full

3 TCP/IP Select the check box to enable the DHCP protocol. Enter the IP address, subnet

mask, and Default gateway values.

4SNMP Select the check box to enable the SNMP protocol, and then select SNMP protocol

options. The SNMP protocol is used for providing and transferring management

information within the network environment. Read community and Write community

can have up to 16 characters. The default community is public. Type sysContact,

sysName, and sysLocation information up to 32 characters. Select Enable

authentication to activate machine authentication.

Note The SNMP Traps tab only appears for the FS-1025MFP, FS-1125MFP and FS-1325MFP connected by

network connection.

No. Item Description

1 Trap Recipient You can select SNMP trap settings for 1 or 2 IP addresses.

Should an error occur, such as Add paper, the machine automatically generates a

trap. The trap sends an error message to one or two predetermined trap recipients.

The trap server is the SNMP trap packet receiver which runs in the application. The

default community is public.

For each IP address, select the Trap Recipient check box, type the name of the trap

community and IP address, and select from available events.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 200 201

No comments

KYOCERA FS-1325MFP Installation Guide Page 76