Kyocera Command Center RX User Manual download pdf (Page 106)

Management Settings

102 Embedded Web Server

SNMP

This section includes advanced settings for SNMP.

If the settings for the item marked with an asterisk (*) has been changed, you must

restart the machine or the network. To restart the machine, proceed to the Reset page.

SNMP Settings

1. Click SNMP under Management Settings on the navigation menu. The SNMP

Settings page opens.

2. Configure SNMPv1/v2c as follows.

SNMPv1/v2c

Activate or deactivate the SNMPv1/v2c protocol. Select either On or Off in the Pro-

tocol Settings page under Network Settings. To configure SNMP v1/v2, proceed

as follows.

Read Community

Enter the community name for SNMP requests to read a value. The default name is

'public'. After you have changed the setting, you must restart the printing system.

Write Community

Enter the community name for SNMP requests to write (change) a value. The

default name is 'public'. After you have changed the setting, you must restart the

printing system.

sysContact

The MIB-II sysContact object. Usually this is the E-mail address of the network

administrator.

sysName

The MIB-II sysName object. Usually this is the host or domain name of the printing

system.

sysLocation

The MIB-II sysLocation object. Usually this is the location information of the printing

system which is described under Location of System Settings page. Go to the

System Settings page under Device Settings to modify the settings.

HP Web Jetadmin Compatibility

Turns HP Web Jetadmin Compatibility On or Off. After you have changed the set-

ting, you must restart the printing system.

Authentication Traps

Specifies whether to use authentication traps. If enabled (On), an SNMP trap is

generated when an attempt to read or write is made using an incorrect community

name. The trap is sent to the configured trap address. After you have changed the

setting, you must restart the printing system.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 117 118

No comments

Kyocera Command Center RX User Manual Page 106