KYOCERA 266ci User Manual download pdf (Page 216)

Chapter 7 Emulation

7-104

OA [Output Actual position and pen status]

The plotter returns the x- and y-coordinates of the current pen position and indicates

whether the pen is currently up or down. This information is given by ASCII-coded inte-

gers in the following format:

X, Y, P TERM

X: x-coordinate in absolute plotter units

Y: y-coordinate in absolute plotter units

P: 0 if the pen is up; 1 if the pen is down

OC [Output Commanded position and pen status]

The plotter returns the x- and y-coordinates and pen status for the last valid pen position-

ing instruction. The pen position and status are ASCII-coded in the same way as the OA

instruction. Coordinate values are given in plotter units if scaling is off, or user units if

scaling is on.

OE [Output Error]

The plotter returns a decimal error number for the instruction executed immediately

before the OE instruction. The error code is converted to a non-negative ASCII-coded

integer whose identity is given in the following table.

OF [Output Factors]

This instruction returns the number of plotter units per millimeter on each coordinate

axis, as follows:

40, 40 TERM

This response indicates that plotter units are equal to 0.025 mm on both the x- and y-

axes. The actual number of plotter units per millimeter is approximately 40.

OH [Output Hard-clip limits]

This instruction returns the lower left and upper right limiting coordinates of the plot

area, in the following format:

LL, YLL, XUR, YUR TERM

LL: lower left

UR: upper right

Error Number Description

0No error

1 Instruction not recognized

2 Wrong number of parameters

3 Illegal parameter

4 (Reserved)

5 Unknown character set

6 Plot position overflow

7(Reserved)

1 2 ... 211 212 213 214 215 216 217 218 219 220 221 ... 259 260

No comments

KYOCERA 266ci User Manual Page 216