KYOCERA 266ci User Manual download pdf (Page 20)

Chapter 1 Introduction to PRESCRIBE

1-12

TEXT "You’re about to enter PRESCRIBE.";

TEXT ’ " " " ’;

In the first command above, the character string starts with a double quotation mark. The

printing system therefore expects the string to end with a double quotation mark, and

regards the apostrophe in the word You ’re as an ordinary character, not as the string ter-

minator.

Similarly, the double quotation marks in the second command above are recognized as

ordinary characters, not as string terminators.

Since an apostrophe or quotation mark can start a character string anywhere in a PRE-

SCRIBE command sequence, it is important not to start character strings unintentionally.

The following examples demonstrate incorrect use of apostrophes and double quotation

marks.

Incorrect:

!R! CMNT Don’t leave stray apostrophes; EXIT;

Incorrect:

!R! CMNT The symbol " means inches; EXIT;

In both of the above cases, the printing system assumes that the expression EXIT; is part

of a character string started by the preceding apostrophe or quotation mark, and fails to

exit the PRESCRIBE mode. The correct way to write these comments is:

Correct:

!R! CMNT "Don’t leave stray apostrophes"; EXIT;

Correct:

!R! CMNT ’The symbol " means inches’; EXIT;

Character strings must not exceed the 255-character limit on total command length. If a

character string exceeds this limit, the printing system terminates it forcibly and begins

looking for the next PRESCRIBE command.

Upper and Lowercase Letters

Regarding upper and lowercase characters, PRESCRIBE follows the same rule as many

computer programming languages: it discriminates case inside character strings and

ignores it elsewhere. You can type command names in upper or lowercase.

Correct:

!R! TEXT ’A’; CIR 1; EXIT;

Also correct:

!R! text ’A’; cir 1; exit;

Also correct:

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 259 260

No comments

KYOCERA 266ci User Manual Page 20