KYOCERA 1020MFP Installation Guide download pdf (Page 91)

7-7

Troubleshooting

Error Messages

If a problem has occurred in the machine, you will be notified by the following display.

• The Attention indicator on the operation panel is lit or flashing.

• An error code appears in the display on the operation panel.

• KYOCERA Client Tool and Status Monitor will show the status of the machine.

If the Attention indicator is lit or flashing and an error code appears in the display on the operation panel, check the

KYOCERA Client Tool or Status Monitor.

Problems that can be resolved by the user are described below.

Note If the indicators light or flash repeatedly in manners not described above, a service error has probably

occurred. Switch off the power switch, unplug the power cord, and then plug the power cord back in and switch on

the power switch. This may clear the error. Even if the error is not cleared, contact your service representative.

Error Code

Message displayed in

KYOCERA Client Tool

and Status Monitor*

Meaning Remedy

C-F040 Error has occurred An error has occurred in the

machine.

Turn the power OFF and then ON.

C-#### Error has occurred An error has occurred in the

machine.

Make a note of the error code displayed

on the operation panel, and contact your

service representative.

(except C-F040)

E-0001 Non-genuine toner is

installed

The installed toner container is

non-genuine.

The manufacturer assumes no

responsibility for damage caused by a

non-genuine toner.

We recommend that you only use

genuine toner containers.

When you want to use the toner

container currently installed, press the

Mode Select key and [Stop/Reset]

simultaneously for 3 seconds or more.

E-0002 Error has occurred The installed toner container's

regional specification does not

match the machine’s.

Install the specified toner container.

E-0003 Memory full Scanning cannot be performed due

to insufficient memory of scanner.

Only the scanned pages are available.

Press [Stop/Reset] and the job will be

canceled.

E-0004 Error has occurred The number of scanned pages

exceeds the maximum number.

The maximum number of scanned

original pages is 99. Only the scanned

pages are available. Press [Stop/Reset]

and the job will be canceled.

E-0007 Add toner The toner has run out. Replace with a new toner container.

Error code E-0001

This is displayed in repeating

two-digit segments (E-, 00, and 01).

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 110 111

Comments to this Manuals

No comments

KYOCERA 1020MFP Installation Guide Page 91

Comments to this Manuals

Related products and manuals for Multifunctionals KYOCERA 1020MFP