KYOCERA 1020MFP Installation Guide download pdf (Page 87)

7-3

Troubleshooting

Vapor is emitted near the

inner tray.

Check if the temperature is low near

the location of the machine, or if the

paper that is being used has been

exposed to humidity.

Depending on the operating

environment of the machine and the

condition of the paper, heat generated

during printing can evaporate water

moisture in the printed paper, emitting

vapor from the machine. In this case,

printing can be continued without any

problem.

To correct this, increase the

temperature in the room, and use

paper that has been stored in a dry

place.

—

Blank sheets are

ejected.

Are the originals loaded correctly? When placing originals on the platen,

place them face-down and align them

with the original size indicator plates.

2-16

Full black printout or faint

printing.

— Open the rear cover and press the

points shown in the figure. If the

problem is not solved even after

printing several pages, call for service.

—

Paper often jams. Is the paper loaded correctly? Load the paper correctly. 2-11, 2-12

Is the paper of the supported type? Is

it in good condition?

Remove the paper, turn it over, and

reload it.

2-4

Is the paper curled, folded or wrinkled? Replace the paper with new paper. 2-4

Are there any loose scraps or jammed

paper in the machine?

Remove any jammed paper. 7-9

2 or more sheets are

overlaps when ejected.

(multi feed)

— Load the paper correctly. 2-11

Symptom Checkpoints Corrective Actions

Reference

Page

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 110 111

Comments to this Manuals

No comments

KYOCERA 1020MFP Installation Guide Page 87

Comments to this Manuals

Related products and manuals for Multifunctionals KYOCERA 1020MFP