Kyocera 1650 User Manual download pdf (Page 108)

Troubleshooting

6-2

The copies come out too

dark.

Is the auto exposure adjustment mode

set?

To adjust the overall exposure level,

perform the auto exposure adjustment

procedure.

Refer to

Chapter 3 in

Advanced

Operation

Guide.

Is the manual exposure mode set? Use the Lighter key or the Darker key

to adjust the exposure level properly.

3-3

To adjust the overall exposure, perform

the relevant exposure adjustment

procedure in each image quality mode.

Refer to

Chapter 3 in

Advanced

Operation

Guide.

A moire pattern (the

phenomenon where the

dots do not appear to be

lined up properly but seem

to be grouped together in

patterns) appears on the

copies.

Is the original a printed photograph? Set the image quality mode to Photo.3-2

The copies are not clear. Did you select an image quality mode

properly according to the type of the

original?

Select an appropriate image quality

mode.

3-2

The copies are dirty. Is the platen or the original cover dirty? Clean the platen and/or the original

cover.

5-1

The copy image is skewed. Were the originals set correctly? When using the platen, set the original

securely along the original size indicator

plates.

3-1

When using the optional document

processor, adjust the original insert

guides securely before setting the

originals.

4-2

Was the paper set correctly? Check the width guide plate position in

the cassette.

2-1

Paper jams occur often. Is the paper loaded properly in the

cassette?

Load the paper properly. 2-1

Depending upon the type and storage

condition of the paper, finished copies

may curl tightly, resulting in a paper

jam. Remove the paper from the

cassette, turn it over, and set it in the

cassette again.

—

Is the paper curled, folded over or

wrinkled?

Replace the paper with new paper. 2-1

Is there any jammed paper or loose

scraps of paper remaining inside the

machine?

Carry out the appropriate procedure to

remove the paper.

6-8

Does the size of the paper set in the

multi-bypass tray match the registered

size?

Make sure the size of the paper set in

the multi-bypass tray matches the

registered size.

2-4

Symptom Items to check Corrective procedure Reference

page

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 139 140

Comments to this Manuals

No comments

Kyocera 1650 User Manual Page 108

Comments to this Manuals

Related products and manuals for Printers Kyocera 1650