KYOCERA FS-C5150DN Specifications Page 104
- Page / 197
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Using the Operation Panel
4-46
Network (Network settings)
This printer supports TCP/IP and TCP/IP (IPv6) protocols.
IP is an abbreviation for Internet Protocol. This printer routinely uses the
TCP/IP (IPv4) protocol, but provides a separate setting for the next-
generation IP, IPv6.
TCP/IP (IPv4) uses 32-bit IP addresses, but the rapid growth in the
number of Internet users has resulted in a shortage of IP addresses. IPv6
was developed to expand the range of available IP addresses by using
128-bit IP addresses.
The options available in the Network settings are as follows:
• TCP/IP (IPv4 settings)
• TCP/IP (IPv6) (IPv6 settings)
1 Press [MENU].
2 Press U or V repeatedly until Network > appears.
TCP/IP (IPv4 settings)
This selects the settings for TCP/IP (IPv4).
The TCP/IP system refers to the Internet system, which has a 5-layer
structure consisting of the interface layer, link layer, network (IP) layer,
transport (TCP/UDP) layer and application layer.
The interface layer is a key layer in the TCP/IP system that provides an
abstracted interface that is not dependent on the link (communication
line: frame relay or Ethernet, etc.) to the IP module (IP layer). This means
that the IP module can use this abstracted interface (which is not
dependent on the link type) to exchange IP packets back and forth with
the link layer.
The options available in the TCP/IP (IPv4) settings are as follows:
• DHCP (DHCP setting)
• Auto-IP (Auto-IP setting)
• IP Address (IP address setting)
• Subnet Mask (Subnet mask setting)
• Gateway (Gateway setting)
• Bonjour (Bonjour setting)
IMPORTANT The DHCP, IP address, subnet mask, gateway and
Bonjour menu options for TCP/IP are displayed when TCP/IP is en-
abled.
1 Press Z while Network > is displayed.
Note Check with your network administrator when selecting the
network setting.
After all network related settings have been done, turn the
machine OFF and ON again. This is mandatory to make the
settings effective!
When COMMAND CENTER is used, network parameters and
security settings can be conveniently changed and checked from
your PC. For more information, refer to the COMMAND CENTER
Operation Guide.
Network >
- FS-1300D 1
- Introduction 2
- Contents 3
- Menu Map 5
- Settings 6
- Legal and Safety Information 9
- License Agreements 10
- Open SSLeay License 11
- Original SSLeay License 12
- Compliance and Conformity 14
- CDRH Regulations 15
- Statement 15
- Communications du Canada 15
- Paper Recycling 16
- Energy Star (ENERGY STAR 16
- ) Program 16
- Environment 18
- Cautions for Toner Handling 18
- About the Operation Guide 19
- Conventions 19
- 1 Machine Parts 21
- Internal Components 22
- Operation Panel 24
- 2 Printing Operation 25
- Printing Operation 26
- Printing a Status Page 27
- COMMAND CENTER 27
- Installing the Printer Driver 28
- Express Mode 29
- Printer Driver User 30
- Guide on the CD-ROM 30
- Status Monitor 35
- Status Monitor icon 36
- Status Monitor Settings 37
- 3 Handling Paper 41
- Recommended Paper 43
- Selecting the Right Paper 44
- Smoothness 45
- Basis Weight 45
- Thickness 45
- Moisture Content 46
- Paper Grain 46
- Other Paper Properties 46
- Handling Paper 47
- Special Paper 48
- Postcards 50
- Envelopes 50
- Thick Paper 51
- Colored Paper 52
- Preprinted Paper 52
- Recycled Paper 52
- Coated Paper 52
- Paper Type 53
- Loading Paper 54
- to avoid 56
- Incorrect 57
- 4 Using the Operation Panel 59
- Message Display 61
- Status Information 62
- Error Codes 62
- Indicators in Message Display 63
- Cancel Key 64
- MENU Key 64
- Arrow Keys 64
- Menu Selection System 66
- Setting a Mode Selection Menu 68
- Report Print 69
- Status Page 71
- Print Fonts List 73
- Print Hard Disk File List 73
- Print RAM Disk File List 73
- Print File (Printing a file) 74
- Copies (Number of copies) 75
- Custom Box) 76
- Job Retention 80
- Quick Copy (Using Quick Copy) 81
- Using Proof-and-Hold 82
- Job Box Configuration 84
- Paper Settings 87
- >MP Tray Type 88
- Paper Size Dial 89
- >>>Duplex Path 94
- ? Enable 94
- >Reset Type Adjust ? 94
- Print Settings 95
- Duplex (Duplex printing) 96
- Page Set (Setting pagination) 101
- Portrait Orientation 102
- Landscape Orientation 102
- Network (Network settings) 104
- TCP/IP (IPv6) (IPv6 settings) 108
- Using the Operation Panel 109
- >>DHCPv6 109
- Device Common > 110
- >Message Language 110
- ? English 110
- Timer (Timer setting) 117
- Security 120
- NetWare (NetWare setting) 122
- AppleTalk (AppleTalk setting) 123
- IPP (IPP setting) 123
- IPSec (IPSec setting) 126
- ID (Administrator ID input) 128
- Color Calibration 137
- 3 Press Z 141
- MH=00000 MV=0 143
- >>M 12345 3 143
- Restart Printer 144
- Service (for maintenance) 144
- Optional Functions 147
- 5 Maintenance 149
- General Information 150
- Toner Container Replacement 150
- Maintenance 151
- Toner Kits 151
- Top Cover 152
- (Top Tray) 152
- Plastic Bag 153
- Toner Feed Slot 153
- Replacing the Waste Toner Box 154
- New Waste 155
- Toner Box 155
- Cleaning the Printer 156
- 6 Troubleshooting 157
- General Guidelines 158
- Direction 159
- Refresh drum 160
- Troubleshooting 161
- Error Messages 162
- Storage Error Codes 166
- Clearing Paper Jams 167
- 2 Remove the jammed paper 168
- Paper Jam in Printer 169
- 3 Close the rear cover 171
- Appendix 173
- Interface 174
- USB Interface 174
- Network Interface 175
- About the Options 177
- Expansion Memory Modules 178
- PF-520, PF-530 Paper Feeder 180
- Interface Slot 181
- Activate applications 183
- Optional Paper 184
- Feeder PF-520/ 184
- Feeder PF-530 185
- Glossary 187
- Glossary-2 188
- Sleep mode 189
- Status page 189
- Subnet Mask 189
- USB (Universal Serial Bus) 189
- Glossary-4 190
- First Edition 2010.10 197
- 2KTKMEN000 197
© 2020, manymanuals.com. All rights reserved. | 0.666 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals