Kyocera KM-C830 User Manual download pdf (Page 128)

8-1

Section 8 OPTIONAL EQUIPMENT

(1) SRDF (Sheet-thru Reverse Document feeder)

Automatically feeds and scans multiple sheet-originals one by one.

Two-sided originals are automatically turned over so that both sides

can be scanned and copied.

● Acceptable originals

• Use sheet originals only

• Paper weight

One-sided originals: Use only originals with a paper weight of

between 35 g/m

and 160 g/m

Two-sided originals: Use only originals with a paper weight of

between 50 g/m

and 120 g/m

• Sizes

8 1/2" x 5 1/2" – 11" x 17" [A5R – A3]

• Number which can be set at one time

100 sheets (smaller than 11" x 8 1/2" [A4] size, between 50 g/m

and

80 g/m

)

70 sheets (larger than 8 1/2" x 14" [B4] size, between 50 g/m

and

80 g/m

)

(The maximum number of originals that can be set when using the

auto selection mode is 30 sheets.)

● Notes on acceptable documents

Be sure NOT to use the following as originals in the SRDF:

• OHP film or other transparencies.

• Soft originals such as carbon or vinyl paper, or other originals that

are badly curled, wrinkled or creased.

• Irregularly shaped originals, wet originals, or originals that have

adhesive tape or glue on them.

• Originals bound with clips or staples. (If you must use such originals,

be sure to remove the clips or staples, and straighten any curls,

wrinkles or creases, before setting them in the SRDF.)

• Originals with cut-out sections or that have a slippery surface on

either side.

• Originals on which any correction fluid is still wet.

• Originals with strong folds. (If you must use such originals, be sure

to smooth out the folds before setting them in the SRDF.)

* In addition, originals with punched holes or perforations should be

set so that the edge of the paper with the holes or perforations is

facing away from the SRDF.

● Names of parts

1 Original table

(Set originals to be copied on this table.)

2 Original insert guides

(Align these guides to fit the width of the originals to be copied.)

3 Left cover

(Open this cover if an original misfeed occurs.)

4 Original eject table

(Originals that have been copied are ejected and stored here.)

5 Ejection extension

(Open this extension when using larger sized originals such as

8 1/2" x 14" and 11" x 17" [B4 and A3].

6 SRDF release lever

(Operate this lever when you want to open the SRDF.)

7 Original set indicator

(Indicated the status of originals set in the SRDF.

Lit green: Originals are set properly. Copying will begin when you

press the Start key.

Blinking green: Reset originals.

Blinking red: An original has jammed. See page 9-14 and removed

the jammed original.

1723 25

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 160 161

Comments to this Manuals

No comments

Kyocera KM-C830 User Manual Page 128

Comments to this Manuals

Related products and manuals for Printers Kyocera KM-C830