Kyocera FS-C8008N User Manual

FS-C8008NFS-C8008DN Color Laser PrinterQuick Reference GuideKyocera Mita Corporation2-28, 1-Chome, Tamatsukuri, Chuo-kuOsaka 540-8585, JapanPhone: (06

8 Install MK[A]†Replace Maintenance Kit A which is dis-played on your printer message window. Replacement of the maintenance kit is necessary at every

9Load Cassette #(A4)/(PLAIN)††The paper cassette matching the paper size and paper type of the print job is empty. Load paper into the paper cassette

10 Load MP Tray(A4)/(PLAIN)††There is no paper cassette installed in the printer that matches the paper size and paper type of the print job. Set pape

11Memory overflowPress GOThe total amount of data received by the printer exceeds the printer’s internal mem-ory. Try adding more memory. Press the GO

12 Print overrunPress GO†††The print job transferred to the printer was too complex to print on a page. Press the GO key to resume printing. (The page

13Sorter tray ##paper fullA tray of the optional sorter (SO-30) is full. Remove paper sheets in the correspond-ing tray as displayed in place of ##.

14 Loading PaperCautionFan the media (paper/transparencies), then tap it on a level surface to avoid media jams or skewed printing.1Loading paper into

15Align the paper stopper correctly with the markings in the cassette that match the paper size:Adjust the posi-tion of the paper guides according to

16 Lower the paper feed roller to its original position. Close the paper feed cassette. Paper Size Indicators PositionPaper GuideSquare the edges of t

17Adjust the position of the paper guides according to the size of the paper you will use.Square the edges of the paper and insert into the MP tray.Se

NoticeNO LIABILITY IS ASSUMED FOR ANY DAMAGE CAUSED BY IMPROPER INSTALLATION OF THE PRODUCT. SOFTWARE USED WITH THIS PRINTER MUST SUPPORT THE PRINTER’

18 Clearing Paper JamsThe figure below is a simplified diagram showing the paper paths in the print system. You can clear paper jams easily and quickl

19[Paper Jam — Right Cover #][Paper Jam — Cassette #]Open the paper feeder right cover according to the number in place of #, top (1) to bottom (3). P

20 [Paper Jam — MP Tray][Paper Jam — Duplexer]Remove the jammed paper onthe MP tray up and towards the right.Upper CoverLower CoverOpen the duplexer d

21[Paper Jam — Paper Transfer Unit]11Open the front cover. Pull the paper transfer unit out com-pletely. Paper Transfer Unit2Remove the paper by swing

22 3Remove the paper on the rub-ber belts (black).4Open the fuser access cover by pressing the green-colored lock lever.Fsc8008q.fm 22 ページ ２００２年１２月１

23 Open the fuser top cover.5Raise the sub-cover by grasp-ing the clip marked as A on the rear side while removing the paper.6Fsc8008q.fm 23 ページ ２００

24 CautionRotate the wheel only in the direction illustrated in the diagram.7If the paper is pinched between the rollers, turn the wheel.8Turn the gre

25CautionUse care not to touch the drum component in the primary transfer unit.Push the paper transfer unit back in completely and close the front cov

26 [Paper Jam — Left Cover]2Open the face-up tray. Open the left cover by pulling the handle.Remove the jammed paper. If the paper is stuck under the

27[Paper Jam — Option Stacker/Finisher/Sorter]Paper jam has occurred in the bulk stacker, document finisher, or sorter which is an optional equipment.

FS-C8008NFS-C8008DNQuick Reference GuideFsc8008q.fm 1 ページ ２００２年１２月１１日　水曜日　午後２時３９分

28 Toner Container ReplacementThe life of the toner containers depends on the amount of toner required to accomplish your printing jobs. When 5 % cove

29Replacing the Toner ContainerNoteYou do not have to turn printer power off before starting the replacement. Any data that may be under printing proc

30 While pressing down the blue-colored lever at the end of the toner container, pull the toner con-tainer out.Take the new toner container out of the

31When the toner container has been replaced, proceed to the next section.Replacing the Waste Toner Box Replace the waste toner box each time you repl

32 CautionDo not put the lid on the opening of a new waste toner box. This could cause damage to the printer.3The old waste toner box has a cap. Remov

33Cleaning the PrinterThe following parts must be cleaned each time the toner container is replaced:• Registration roller•Belts• Main charger wire• Ma

34 1Clean the metal roller as shown (the registration roller) using the cleaning cloth (included in the toner kit).2Rubber BeltsClean the rubber belts

35Cleaning the Main Charger UnitThe main charger unit needs to be cleaned periodically as it gets contaminated with dioxide after a long usage, causin

36 When finished, remove the grid cleaner from the printer and discard it. The grid cleaner cannot be reused.Close the front cover.Grid Cleaner2Cleani

FS-C8008NFS-C8008NFS-C8008NFS-C8008N

2 ContentsGuide to the information about the printer ...3Understanding the Error Messages ...

FS-C8008NFS-C8008DN Color Laser PrinterQuick Reference GuideKyocera Mita Corporation2-28, 1-Chome, Tamatsukuri, Chuo-kuOsaka 540-8585, JapanPhone: (06

3Guide to the information about the printerThe following documentation and CD-ROM are sup-plied:Installation Guide This guide provides information on

4 Understanding the Error MessagesThese messages appear on the printer’s message dis-play when the printer needs the operator’s attention. For more de

5Cassette #not loadedThe corresponding paper cassette is not installed. Install the cassette. The cassette number can be 1 (topmost) to 6 (bottom); an

6 Duplex drawernot loadedThe duplex drawer is not installed. Install the duplex drawer. This message is appli-cable to the DN model.Face-down tray pap

7Format errorHard diskThe hard disk installed in the printer is not formatted, and therefore cannot be read or written. To format the hard disk, follo