KYOCERA FS-3820N User Manual Page 92
- Page / 227
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Interface
1-76
Serial Interface Parameters
This section applies to the printers having the option serial interface
board kit (IB-11) installed.
The baud rate, data bits, stop bits, parity, and protocol for the serial
interface can be set as follows:
1
Press the MENU key.
2
Press the or key repeatedly until Interface > appears. One of
the interface names shown below appears, indicating the current
interface.
Parallel (default)
USB
Network
Serial (when a serial interface board kit is installed)
Option (when a network interface card is installed)
3
Press the ENTER key. A blinking question mark (?) appears.
If you want to abandon the interface selection procedure, press the
CANCEL key. The interface remains unchanged.
4
Press the or key repeatedly until Serial appears.
5
Press the ENTER key again.
Option
Interface
? Parallel
Interface
? Serial
- FS-3820N 1
- FS-3830N 1
- Caution on Installation 2
- Notice on Software 2
- Notice on This Guide 2
- Regarding Tradenames 2
- Agfa Japan License Agreement 4
- Cautions for Toner Handling 4
- Contents 5
- Introduction 10
- Features 11
- For More Information 14
- Guide to the Operation Guide 15
- Using the Operator 17
- Message Display 18
- Interface Indicator 19
- Paper Size Indicator 19
- Paper Type Indicator 20
- CANCEL MENU ENTER 21
- Menu System Road Map 22
- Printing Test Pages 28
- MENU MAP 29
- FS-3830N Page Printer 29
- Status Page 30
- Status Page 30
- Status Page ? 30
- STATUS PAGE 31
- NETWORK STATUS PAGE 35
- Font Lists 38
- Paper Handling 40
- Paper Handling > 41
- >Cassette Size > 42
- Custom 42
- >Cassette Size 42
- ? Custom 42
- >>Unit 43
- >MP Tray Size 45
- >MP Tray Type 47
- >Type Adjust > 48
- Custom 1 48
- ? Custom 1 49
- >>Paper Weight 50
- Normal 2 50
- ? Normal 2 50
- >>Duplex Path 51
- Enable 51
- ? Enable 51
- >Reset Type 52
- Adjust ? 52
- MP Tray Mode 53
- >MP Tray Mode 53
- Cassette 53
- Pagination 57
- >> I000 61
- >>?I000 61
- Print Quality > 69
- >KIR Mode 69
- Ecoprint setting is Off 70
- (default) 70
- Ecoprint setting is On 70
- Quick Copy 73
- KM-NET Job Manager 81
- Job Manager Icon 82
- Printing a List of VMB 85
- >List of VMB 85
- >List of VMB ? 85
- ? Parallel 92
- ? Serial 92
- Network Interface Parameters 94
- ? Network 94
- Operating the Storage Device 97
- RAM Disk Mode 98
- >RAM Disk Size 98
- 0087 Mbyte 98
- Writing Data 100
- Memory Card > 100
- >Write Data 100
- >Write Data ? 100
- FS-3830N Page Printer 101
- >Read Fonts ? 103
- >Read Fonts 103
- Formatting a Storage Device 104
- >Format 104
- >Format ? 104
- Configuration 107
- Paper Selection 124
- General Guidelines 125
- Selecting the Right Paper 126
- Special Paper 130
- Adhesive-Backed Labels 131
- Paper Type 135
- Maintenance 136
- Toner Container Replacement 137
- Replenishing Toner 138
- New Toner Container 139
- 10 times or 139
- Protective Seal 139
- Waste Toner Box Replacement 141
- New Waste Toner 143
- Cleaning 144
- Cleaning the Charger Grid 145
- Grid Cleaner 146
- Charger Unit 146
- Charger Roller 146
- Paper Transfer Unit 148
- Troubleshooting 149
- ) position 150
- Print Quality Problems 151
- Table 4-2 (Continued) 152
- Indicators and Messages 154
- Maintenance Messages 155
- Table 4-4 (Continued) 157
- Error Messages 158
- Correcting a Paper Jam 160
- key. The display will show 161
- key. The previously 161
- Registration 163
- Rear Cover 163
- Pull out 164
- Examples of online help 166
- Paper Feed Gears 166
- Jam at the MP Tray 168
- Chapter 5 169
- List of Fonts 170
- KPDL Fonts (1) 173
- KPDL Fonts (2) 174
- Appendix A 175
- Available Options 176
- Expanding the Printer Memory 177
- DIMM Sockets 179
- Installing Option Units 183
- Load Limit Load Limit 185
- Clip Clip 185
- DU-61 Duplexer 186
- SO-60 Sorter 189
- Sorter Cable 191
- To p ri n te r 192
- Power Cord 192
- To power supply 192
- Duplexer 193
- EF-60 Envelope Feeder 195
- Bottom Tray 196
- Sub-tray 197
- Paper Guides 197
- Paper Setting Button 198
- PT-4/PT-60 Rear Tray 199
- Network Interface Card 200
- Network Cable 201
- Microdrive (Hard Disk) 202
- CompactFlash (Memory) Card 204
- Host Computer 205
- Interface 205
- Parallel Interface 206
- USB Interface 209
- Serial Interface (Option) 210
- RS-232C Protocol 211
- PRESCRIBE FRPO D0 Command 213
- RS-232C Cable Connection 214
- Specifications 218
- Table C-1 (Continued) 220
- Glossary 221
- ©2003, 2004 227
Related products and manuals for Copiers KYOCERA FS-3820N
Copiers KYOCERA KM-1810 Datasheet
(4 pages)
(4 pages)
Copiers Kyocera CUA 25307 User Manual
(87 pages)
(87 pages)
© 2020, manymanuals.com. All rights reserved. | 2.291 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals